|
|
|
04-20-2017, 11:27 AM | #1 |
New Member
6
Rep 25
Posts |
New Rotors & Pads
Im looking to replace the rotors and pads at the same time with the stock replacements as they have provided good bite and I don't want to deal with any squeaking. I would assume changing the brake fluid at the same time would be the move. Is it beneficial to switch to stainless steel brake lines?
The car is also recently out of warranty and I am closely located to Turner Motorsports and may start to have them as my "go to" shop, should I have a good first experience there. |
04-20-2017, 11:37 AM | #2 | |
Major
545
Rep 1,233
Posts |
Quote:
The rear brake lines are a bit more work and if I'm not mistaken may require the subframe to be lowered a bit. If you are doing that, maybe consider upgrading your rear subframe bushings also Slippery slope! |
|
Appreciate
0
|
04-21-2017, 08:55 AM | #4 |
Major
545
Rep 1,233
Posts |
Are you on runflats? They cause more harshness than the RSFB, but you would perhaps notice a small increase in NVH rather than ride harshness. Any reason you want to go full aluminum vs OE M3 rubber or poly? Unless you have a race car going to all metal is probably a very small increment/improvement over harder rubber or poly. There are a few types of poly that are 2 piece which make them easy to install (Whiteline for example)
|
Appreciate
0
|
04-23-2017, 04:15 PM | #5 | |
Supreme Allied Commander
3847
Rep 54,376
Posts
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Performance Friction, www.hpautosport.com
|
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|