[PunjabiM3]

I got done installing the KWV3 yesterday. The front ride height is darn close but the rears are too high (I left the ring in the middle of the collar). So now I have the rear of the car lifted off the ground, but I CANNOT get the stupid adjustment ring to spin. The entire assembly (ring and the threaded collar) turn when I try to adjust it. My guess is that there is too much load from the spring. Is there any way to get this thing to work or is my ONLY option to go through the pain of uninstalling the lower control arm, strut from the entire assembly and then adjusting the ring? I sure as hell hope not because it was a bitch to get everything to line up back there during the install. Hope to get some feedback on this!