1&done -
My local shop installed the rear coilovers without using the rubber seat that is located between the vehicle body and the rear height adjuster.
I'm wondering if it's worth bringing it back to have it installed properly. (I've already had the car back once because the Swift thrust sheets were installed backwards.) Argh.
I haven't had the chance to drive the car very much since installation, so I'm not entirely sure if there is any added noise at this point without the rubber seat in place.
Quote:
Originally Posted by 1&done
I did install a pair of 65mm needle bearings on the rear, I have not touched the front just yet. I plan to install another set up front if the noise persists after I install adjustable away bar links. I have zero noise in the rear now.
|