Quote:
Originally Posted by Superastro
How do I get the window to go up just a smidge higher so that it fully tucks into the upper seal? Currently everything works as it should (the window drops down slightly when the door is opened, and it goes back up when the door is shut), but my driver's side window is just a tad low so that the top seal isn't fully engaged when the door is shut.
I've tried resetting the window limit a number of times as described in this thread, but it hasn't solved my tiny problem.
Ideas?
|
I had the same problem as you, except for the passenger side. Assuming you have done the limits right, and it still does not fully seal, then what you have to do is remove the door panel, and basically the window is held by two fixtures. all you have to do is loosen them both up and physically pull the window up and tighten it back. over time the window slowly drops. NOTE: you need to make sure that you physically lift them up equally. And then you can reset the limits.