Quote:
Originally Posted by Dilmorecg
I just did this last weekend and I used a dremel with the wire brush attachment. It took 30-45 mins per side (just to clear the goop). I had to get a mirror to make sure I cleared everything out. It is a real pain to roll the rears.
|
Dremel with brush attachment is what I used as well. In fact I ALSO used a small cutting disk attachment... take your time and stick your head under there and wear some glasses. Avoid using the highest speeds as it will just heat up the goop and start to melt it (no good). Take your time and run the disk down the length of the material on one side, than again on the other... you're essentially
CUTTING A V-SHAPE of the goop out 
From there you can grab it with some vice grips, and you should be able to tear it out, even if in 3" lengths.
Also helps if you're not doing this in sub-80F weather... that stuff is BARELY pliable.