View Single Post
      09-08-2015, 06:38 PM   #142
KNS
Lieutenant
139
Rep
439
Posts

Drives: 128i and Porsche
Join Date: Dec 2014
Location: Arizona

iTrader: (0)

Well, I went ahead and installed the Whiteline inserts in the rear of my non sport 128i. One of the original factory bushings was leaking out its oil. Surprising as the car has less than 30,000 miles.

The install was straight forward (this is a great thread!). My right rear side of the car is about 1/8 inch higher which is strange and I'll have to look into that and recheck torque later on. My original measurements might have been slightly off...

Definite improvement in the car's handling (I've got non runflats). I'm even getting a little bit of tire squeal in hard corning - never had that before. Eventually I may get the M3 bushings or something similar but these are well worth the time and money.
Appreciate 0