Quote:
Originally Posted by iminhell1
You have a bent control arm or something. My opinion. Have since the first alignment.
Just quickly looking over other alignment pics, caster should be virtually identical. Adding/subtracting camber by knocking the alignment pin out isn't going to change caster.
To do that you need to adjust front to back, which the holes in the tower don't allow. Camber plates may, I haven't looked much at them.
I hate to steer you down an incorrect path, but I kinda think a bent arm is what you'll find here. Might be able to look through one of fe1rx's threads for length specs of the arms.
|
Agreed - never seen caster that different side to side, at most a .1 difference but not what your alignments are showing. Indicates something else is off somewhere - which could be leading to uneven wear and other problems (that they tried to blame on your plates potentially)