Quote:
Originally Posted by iminhell1
You have a bent control arm or something. My opinion. Have since the first alignment.
Just quickly looking over other alignment pics, caster should be virtually identical. Adding/subtracting camber by knocking the alignment pin out isn't going to change caster.
To do that you need to adjust front to back, which the holes in the tower don't allow. Camber plates may, I haven't looked much at them.
I hate to steer you down an incorrect path, but I kinda think a bent arm is what you'll find here. Might be able to look through one of fe1rx's threads for length specs of the arms.
|
All my control arms are new(as of 2018 from fcpeuro, trw "m" kit front and rear)...
I'll get down there again and check though just to be safe...
I did a full inspection a couple of weeks ago and found nothing out of place, but it doesn't hurt to check again...
What do you guys think i should do?
Could it also be that it wasn't aligned properly?