Quote:
Originally Posted by wdb
Sheesh! Amazing work. Can't wait to hear it run.
|
Thanks! You and me both.
Got the Turbofold blankets on.
Got the manifold heatshield wrapped in the heat tape.
Heat shield and blankets on.
Secret to getting the rear inlet on, remove the wastegate actuator bolts and swing it out of the way. I thought this was going to be a nightmare based on what I read, but it wasn't bad, and if the vertical portion of the inlet was longer it would have been cake.
Inlets relocated.
Turbos, new water pump, low temp thermo, etc.. installed.
