|
ekpm2 coding for e100 / higher amp load
anyone coded their ekpm2 module for e100 / higher amp load to remove the error when running a stage2 LPFP
I attempted with protool but it says coding is not available for the control unit EKPM60_3_03
i'll admit I've not loaded it up in ncsdumy yet to see if they have predefined the values for removing the amp draw error
__________________
You only need two tools in life - WD-40 and Duct Tape. If it doesn't move and should, use the WD-40. If it shouldn't move and does, use the duct tape.
Driving e82, e72, e85, R53 Gone but not forgotten..
1974 2002, many various 3s.
|