|
Ready for friday. Bumper and pans are back on. I mentioned that I did the SPL arms and don't think I covered that you need to do a little bit of grinding to get them to work with 17 inch wheels. While under the car screwing in the pans I shot these. You can see when the nut was ground down a bit and in the next shot how tight the clearance is. Last shot shows how much or little the fender has to be moved to get the tires to fit. Will get these worked with an english wheel and then paint. If some of the area where the fender attaches to the cover need to be ground down or off I will make small aluminum plates that will tie the two pieces together. A friend of mine did this with his race car and they work out well.
|