[QST4IT]

What's up guys.

So decided to upgrade my standard HiFi to a top Hifi in my E90 because I had a local car I was picking parts from so just made it an interesting & cost effective little upgrade. So all my speakers are swapped I added the rear door cards and speakers\tweets, center channel in dash wired up etc. etc. Easy

I have the L7 amp installed. I picked up an adapter for the amp to go from smaller Hifi amp plug to the larger L7 amp plug for speaker wires. Plug & play - Setup for that was super easy.

I'm pretty savvy usually on this stuff, but still just struggling to wrap my head around where to draw the 2 fiber optic lines from that supply the L7 amp.

My fiber optic plug I purchased for amp has two optic cables to the amp and both have enough length of fiber cable to run to the dash but best I can tell I have nowhere there to plug them to. (unless I'm missing something)

Head unit has (2) that are taken up.
My Car already has the most distribution block at rear seat. Seems like I could jump from Most block. But I'm assuming it requires one in- one out for each line so still need a source.

As I said struggling to wrap my head around what seems like it should be a fairly easy tap into the fiber system.

Any tips , thoughts suggestions would be much appreciated.
I Imagine I'm over thinking it , or just missed something in my homework.

Thanks