|
manual swap
hi, I've just finished a manual swap and mechanically all is fine.help! I've got an e82 (2008). There have been difficulties with the additional wiring of brake and clutch, so I've changged the VO to not needing the clutch for starting.(KPS and KLR disabled)
Problem is no crank!
The car is in overall good condition, the starter runs if solenoid is shortened. Most likely I don't have ELV , however there is no lock engaging. VO order coded with Protool and seems to be ok.
Faults are in CAS (A0B5) about road speed signal , and in DDE (4DF3) torque trans wrong. Nothing that should trigger no crank.
There is a synchronization between CAS and DDE called "reset starter lock" that is showing on Protool but it is not working. When performing the synch it replies "failure" (Ox90). But I received info that this synch is not necessary.
What way is there to find systematically the reason for no crank?
do you have an idea from your experience?
|