[adrean8j]

So I just changed mine as well (GP Thunder 7500). The passenger side was not really HARD persay but more time consuming. You do not need small hands.

1. Remove the bracket with the two reservoirs.
a. Loosen top left bolt
b. Loosen lower forward bolt on bracket.
c. Remove nut for the forward reservoir, then set reservoir on plastic engine cover.
d. Remove lower rearward bolt on bracket.
e. Take out bracket.

2. This should leave plenty of room to work and take out lamp. Lamp rotates counter-clockwise for removal.

Remember the the plastic cover ROTATES in counter clockwise from left to right. This will insure both clips on the bottom slide into position. You may have to tuck wire wrap going to your Xenon ballast in a bit so it does not catch on the cover. The rest is exactly the same as the driver side! Good to go!