|
Alright guys...I just did this to my car. Used a dremel rotary cut tool (the disc one) and cut the flat divider out about 3/8" away from each end. Used the sanding tool to sand it down. Took all of about 5 minutes and it really makes this thing look sporty. I took a good look at #11 to see if I was going to go the permanent cut route or not and it would not look right. The #11 piece has sort of a border all around that covers up some tabs and other non-finished looking bits. It looks great...will post a pic later but it looks just like the OP's as mine is the same color.
|