|
OK, well that didn't quite work! I think I'm getting closer though. I procured my Bavarian Technic Cable and software. There are clear errors in the FRM:
9CBB
Short-circuit 2
Error will not cause a warning light
Error is currently present
Test conditions have been completed
Short circuit or signal interruption
9CC0
SMC right defective
Error will not cause a warning light
Error is currently present
Test conditions have been completed
Timeout
9CC1
Communication with mirror driver side defective
Error will not cause a warning light
Error is currently present
Test conditions have been completed
Signal or value below threshold
If I use the Activations section of the FRM module and for the right headlight on, the xenon illuminates. The software will not allow me to clear the error codes in the FRM. I've now fallen into some rabbit hole involving tool32, etc., but I'm struggling a bit. I'm not even sure that the Bavarian Technic cable will work with the other software that I've found Googling around. Any quick tips? Is my FRM shot?
|