[JimD]

I've purchased new pads (Brembo) and sensors and may replace my brakes Saturday when I change the oil. But I checked the pads when my light came on and they are fine, I don't think they really need to be replaced. I also tried shorting out the sensors and I was still unable to reset the service due for the brakes. I will try again with two new sensors and new pads (not that the car knows the pads were replaced).

But what I would like to do is to code out all the service due warnings - or if that is not possible, code the intervals to be so long it is essentially coding them out. Does anybody know which software module contains these settings (I use NCSExpert for coding).