View Single Post
      10-30-2010, 12:18 PM   #10
ianc
Ex '87 Carrera
ianc's Avatar
United_States
246
Rep
1,259
Posts

Drives: '10 TiAg 6MT 135i
Join Date: Feb 2010
Location: Redwood Shores, California

iTrader: (0)

If you examine the front lower half of the armrest, you'll see that BMW has put two small circular rubber pads there to prevent contact between the halves. They did not do this at the rear for some reason, and hence the two halves will rub against each other there and squeak. If you are having this problem, examine the horizontal surfaces toward the rear to check for scuff marks. If you see rub marks, then the armrest is likely squeaking and the noise can be cured by adding pads of rubber to isolate the two halves as I have suggested. I should add that felt is not the ideal material to use for this because it does not have the 'spring' that rubber does to resist compression.

Frankly, I'm a little disappointed in this thread. I had suffered the annoying squeaks for awhile and was able to completely cure them by this method, so I thought others might benefit by my posting it, but instead I'm just greeted with skepticism, condemnations of BMW's part quality (not totally undeserved), or implications that it's not fixable and to just 'live with it' from people who haven't tried it.

Oh well, whatever...

ianc
__________________
"I will tell you there is a big difference between driving money and driving blood, sweat and tears." - PorscheGuy79

"I got 328 loaner and was impressed with performance. It feels much faster than my 135i." - MOCKBA
Appreciate 0