Quote:
Originally Posted by SpencerMH
Hello, got the seat heater harness installed and i get the same thing, push the seat heater button and it turns on then off after 2 seconds same as before i had the harness installed.
I had the seats coded for airbags and it went well, anyone know if I need to recode for the heated seats now? From EvoKnvl it doesn't sound i should.
I bought two cables for two seats and you only need one wiring harness FYI in case anyone else is ordering the wiring harness.
|
Spencer, just want to verify. Your original seats were power seats or manual? If they were power seats, did you use the stock control module under the seat? Also, did you get the correct cables? I had to use 2. One for each side. You're basically stripping all the wiring out except for I think 2 things on the driver, and 3 on the passenger. I would need to check my harness to be sure.