Quote:
Originally Posted by JimD
Looks good. I used a Garmin rear camera because it interfaces with my always on GPS on the left of the instrument cluster. It transmitts wirelessly but I had the same sort of wiring to do in the rear.
My main reason for comment is my way of getting the camera signal into the trunk where the transmitter is. I pulled out the trunk latch and drilled a hole in it's plastic housing for the wire then snapped it back in place. I like the idea of the hole in this latch which could easily be replaced rather than the trunk.
|
Sounds good, Jim. I drilled a hole in the right license plate pop out unit right next to the slot for a screw driver to remove it (see photo above). was very easy to do.. popped it out, removed the connector, took it over to the bench and drilled the hole, then popped it back in place and fed the cable through it. I didn't drill any holes through the sheet metal.