Quote:
Originally Posted by GoodMoodley
I just did the swap a couple months ago. Got a similar press set to the post above mine. Was a fairly easy job.
I do have camber plates up front and had the alignment set up with negative camber in front and rear.
With this setup I am now able to run the Apex ARC-8 in 17x9 ET42 in a square setup with 255/40/17 RS4s. I put 3mm spacers in rear and 5 mms in front and have no rubbing. No fender work has been done.
|
Hi! I see you have a LCI 135i like me. What hubs did you use for this? Did you use the pre LCI or the LCI part number?