Yeah, had a go recoding the modules and no luck.
I think its maybe because I coded $544 without removing $540 (regular cruise). Tried deleting $540 and then adding $544 and it has different behaviour. I no longer get cruise control failure on startup, and no error codes present in INPA. But when I try to activate cruise, I get this code from the DSC module:
Quote:
DSC
5E64 5E64 - PT-CAN Instr_Cluster3 plausibility err_1
Error counter: 1 Logistic counter: 40
Vehicle speed 58.00 km / h
Brake Light Switch 0/1 00:00
Bremsfluessigkeitsschalter 0:00 0/1
ASC / DSC_aktiv (pushbutton function) 1:00 0/1
Brake pressure detected 0.00 0/1
ABS control 0:00 0/1
ASC control (BMR) 0.00 0/1
ASC control (AMR) 12:00 0/1
GMR control (GMR) 12:00 0/1
GMR control (MMR) 12:00 0/1
CBC regulation 0:00 0/1
MSR-control 0:00 0/1
TDR scheme 0:00 0/1
SDR-control 0:00 0/1
DBC control 0:00 0/1
RTA actively 1:00 0/1
Run-Up Mode 0.00 0/1
***no suitable error symptom. Fulfills test conditions
Error not currently available, but already stored error would not cause illumination of a warning light
Error code: 5E 64 20 01 28 08 00 04 3F 3A DE
==================================== =========================
|
Person on another forum experienced this error when they didn't VO code their KOMBI. Although I definetly did code my KOMBI as the warnings on startup went away.
Has anyone got a TRC file for their DSC module? Annoyingly its the only module I haven't got a backup of