I ordered the part from ECS, and it finally arrived. I plan to put it into my 1M.
Is this a job I should do myself, or should I take it to the dealer? There were no instructions accompanying the parts box. Does this parts set just click in where the panel over the area would come out?
For the Littlefuse part, do I need the ATO version
https://www.amazon.com/Littelfuse-FH...A200BP+ATO#Ask Or the mini-ATO:
https://www.amazon.com/-Circuit-func...s=FHA200BP+ATO ?
Was there any need to disassemble the dash for running the wire(s)? I am assuming you need to run some wires with crimpers on them to reach the fuse box.
Thanks in advance!