cp-e DCI Install Fail
So I undertook my first "successful" mechanical install last night installing my new cp-e DCIs, or so I thought.
I had some issues inserting the metal coupler into the factory accordion intake pipes because the fit was extremely tight. I managed to push them in about 1/2 an inch and tightened the hose clamp and tried tugging on it a bit. It seemed ok.
I installed the filters on and took it for a short drive and rechecked the install and it seemed nice and tight still.
After getting home from work today I took another look and both of the intake filter couplers had popped out of the accordion pipe.
I reinstalled the intakes, this time managing to push the couplers the full 1 inch in as the engine and pipes were quite warm allowing it to more easily push in.
Now the engine seemed fine on the drive home and I have no warning lights but for some amount of time my intakes have been sucking in unfiltered air...
Out of 10, how worried should I be?
|