I run 275/35/18 square. The diameter is about 1/4" less than stock diameter on the front, and I still rub at full lock, albeit slightly.
Interestingly, I rub on the rear of the fender liner not the front (revised liners). I am lowered 20mm and run -2.5 degrees camber, stock caster.
Honestly, I can't imagine how a 295 width can fit.....awaiting details
__________________
1M track toy mods: BMS chargepipe, BMS OCC, ADE FMIC, ADE motor mounts, MadDad/Lightweight Ti exhaust, ADE custom oil thermostat/cooler, custom MHD tune, F10 550i clutch, Ohlins R+T, Vorschlag camber plates, M3 'vert FSB with Turner endlinks, Stoptech Trophy BBK.
|