View Single Post
      07-18-2013, 11:42 AM   #1
HP Autosport
Supreme Allied Commander
United_States
3847
Rep
54,376
Posts

Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Performance Friction, www.hpautosport.com

iTrader: (36)

Thumbs up Swift Spec-R Sport Springs for your E82 135i

Swift made Sport Springs Spec-R is made for true track racing enthusiasts that wants to take their vehicle to the next level.
Sport Springs Spec-R is engineered with 2 main characteristics.

1 Redesign lowering ride height to maximize the suspension performance allowing the vehicle to fully absorb road condition for maximum traction.

2 Increase in spring rate to further enhance cornering speed through entry & exit. The increase in spring rate is based on the vehicle factory stock valving settings. Sport Springs Spec-R is increase to the optimal rate that the stock shocks can handle. Higher performance shocks are not required, but recommended.

Spec R springs are wound with the same engineering as our sports springs. With the exception of stiffer rates and slight change in ride height; you can expect the same characteristics as our sports springs.



H5S.TW

Motorsport's most advanced spring material


Swift made a name for itself on the tracks of Asia, Europe, and U.S. by defying all accepted concepts and speculations about the future, if any, in coil spring science.
When many other company were looking at expensive and brittle titanium composites to create the next evolution of springs, Swift was looking at reinventing the entire science of coil spring dynamics. Swift saw that most others are using the old regular silicone chrome material, which was not strong enough. It used a heat tempering method that damaged the strength of the material that requiring more coils, in turn, more weight.
The material was also suffering from a short life span. With springs like this leading the industries, Swift saw room for improvement.

Swift's R & D team created material, called H5S.TW, which is stronger then regular silicone chrome material. Because of this material, we could make the spring wire thinner, and could wind the springs with fewer coils, which greatly decreased weight while dramatically increasing available stroke.

135i lowering:

1" in the front and 1" in the rear (from non-sport).

Spring rate:

-3.6kg/mm or 201 lb/in in the front
-9kg/mm or 503 lb/in the rear

Independent review here:

http://www.1addicts.com/forums/showthread.php?t=873692

NLA
Attached Images
   

Last edited by HP Autosport; 05-09-2023 at 02:19 PM..
Appreciate 0