[flensborg]

Sorry, but i can't find out how to insert pictures in the post, so they are attached. It is my first post on the forum.

Picture 1:
Make a cut in the back of the light.
Picture 2:
Open up, but bee a bit careful.
Picture 3:
Carefully take up the circuit board. Pull of the connector and cut the wires at the connector.
Picture 4:
Clean the connectionarea and sold on the wires as on the picture.
Picture 5:
Replace circuit board and add a little glue on the two pinns.
Picture 6:
Add silicone to glue the back of the light together.
Picture 7:
Let it dry before mounting in the car.