Quote:
Originally Posted by fe1rx
Reporting back ...
I chose to fabricate some nesting angles from 4130 0.100" chrome-moly sheet, tig welded. The geometry is a bit of a challenge given that the angle isn't 90° and the vertical surface isn't flat.
Attachment 1821042
The angles ensure that any vertical load is transfered into a wide length of the bulkhead vertical skin. A shim is necessary though to maintain a level mounting plane for the roll bar foot.
Attachment 1821043
Here is the top view of the LH foot installation.
Attachment 1821046
And here is the bottom view.
Attachment 1821047
RH side is similar up top.
Attachment 1821048
But the bottom is simpler in the absence of fuel lines.
Attachment 1821049
I put the rear seat bottom back in just to provide a finished appearance, but the rear seat backs will remain removed.
Attachment 1821044
Here is a look with the driver's seat installed.
Attachment 1821045
|
I want to do this exactly, except with a sparco evo seat