Quote:
Originally Posted by Tambohamilton
Eventually figured I could just measure the Z height of a reference point front in each of the front and rear (wishbone inner end at the front, and camber arm inner end at the rear). I measured from a string line under the tyres, with the wheels up on a couple of 1" boards just to make sure the string line was off the ground.
At some point I'll need to go back through the whole model and check it all, but for now I'm content that it's giving me reasonable figures. Magic number spreadsheet is coming together now...just a few bumps to iron out.
Thanks again, fe1rx for the data!
|
You are welcome.
Good to see that you are cross checking your assumptions against real world measurements. This is definitely essential!