|
Fe1rx, did you publish the strut top coords at any point?
I saw the photo of you running a plumb line down so assume you took at least the x/y coord?
I’m running an E81 130i and trying to determine the base configuration.
From what I can see I can derive everything else from what you’ve very kindly shared, but without the strut top constraint (yours is set at -3deg camber and 7.3deg caster), it’s hard to create a model of the standard setup.
I could of course use the 130i alignment data to feed in camber and caster to derive the top mount xy position, but it’d be good to know the inherent camber/caster with the real measured constraint you have.
Thanks for any help
Dave
|