Just installed them today and ran into some fitment issues with since the new foam pad is alot thicker, but if you stick a few credit cards or use a taped up screwdriver to push the bottom up and then tighten it it still fits well.
I also snapped a picture incase anyone needs it, its an extremely straight forward install.
-take out the center trunk floor piece
-disconnect negative terminal
-remove the plastic piece in between the tail lights (inside trunk - has 2 screws and 2 tabs(?) holding it)
-take out one tab on each side of the inner carpet and pry it back to reveal the tail light assmebly
-remove 3 8mm bolts (red circles)
-unplug two connectors (blue squares)
-then simply pull the lights out and reverse to install
Hope this helps anyone that is unsure of the diy
As usual, I'm not reliable for any damages to your car and please be careful and patient when you work on your car