Since there's no "real" DIY on here with pictures i thought i'd make one.
Tools used:
1. Painter's tape
2. Small Ruler
3. Sharpie Ultra Fine Marker
4. Dental Floss
5. Hair Dryer
6. Pair of small pliers
7. Couple small towels
8. Goo Gone
First i placed painters blue tape around the OEM pieces and with a ruler marked off where each character starts/ends.
I then used a hair dryer to warm them up then dental floss to get them off, i started on the right.
This shows the adhesive left after using the floss. This can be easily removed with your finger nails.
Cleaned risidual adhesive left with Goo Gone then soap and water to get off any oil.
For the smaller characters "1" and "i" i used a pair of pliers with some tape around prongs so they wouldn't damage them.
Finished product
Overall i'm really happy with the outcome. These are
Bimmian Matte pieces they also come in high gloss black but i decided to go with matte since my car is already black. I was really pleased with the finish and quality of them, the double sided tape is a little thicker than OE but it's not noticable unless you're looking for it. Hope this helps anyone that will be doing this in the future.