Quote:
|
Originally Posted by cedavis34
Thanks for the excellent write-up, I have 4 of 6 done, and I have a question for those of you that have done this. What did you guys do with the little bit of metal flakes/dirt thats down in the channel after you remove the old plug but before you put in the new one?
It would be very difficult to photograph so that's why I'm not posting a picture, but I worry that it might affect the seal of the spark plug washer to the head? My vacuum isn't narrow enough to get down there, but I could rig something up. Did you guys worry about it? I haven't done anything about it, but I'm starting to question if I should have.
I also found that a mouse had been chewing on one of my coil wires, which is ridiculous because this car is a daily driver.
Thanks for your help!
|
Use a vacuum cleaner, if you notice any sand falling inside
, you can start the engine without any spark plugs. The engine will blow it out
.