[Turbmando]

Today I installed my OEM BMW Performance Diffuser and overall things went well.

I did run into one little issue and I wanted to see if others have had the same fitment problem. All of the clips fit with a satisfying snap, except for the driver side clip to the left of the exhaust tip. It just slides into place and easily slides back out when pulled. Once the screws are inserted it fits well and feels snug, but it is definitely not clipped in.

I took a look from under the car and there is a gap where light shines through. I do not believe i have made the clip hole any bigger when I uninstalled the original diffuser. The clips do look much more pronounced and formed on the original vs. the performance diffuser and I bet the original one would clip in properly.

I am just looking for some advice on whether this is normal and if I should return it or not.

Thanks.