So finally got around to dropping those hubs off at a local driveline shop. They pressed out the driveshafts out the drive flanges. Was a good feeling seeing them finally out of those ugly hubs!
If you look at them, the right side is actually longer than the left side. I wonder if that contributes to any torque steer? The lengths don't differ by much though.
Then, as I start cleaning up the splines and threads I notice something very bad:
Very very bad
They have not pressed them out squarely on the press and have mushroomed the right side driveshaft. The thread is squished and theres a big bulge. Shit.
Pretty pissed, looks like I need a new driveshaft. Will need to go back to the driveline shop and hopefully get my money back
They charged quite a bit of money for this work and they're a driveline specialist so I would have expected them to do this properly.