Quote:
Originally Posted by 1&done
I spoke to Jake at Öhlins to clear things up. Instructions say to use provided spacer, this is incorrect, you must use the OEM spacer. The Öhlins spacer is for the E9X w/ EDC, guess they thought 1Ms have that too. The 2nd issue was the apparent "flexible" spacer missing. Jake said this is a typo and there should be no such spacer...note the misspelling. I have a set of roller needle/ thrust bearings on order. These are usually supplied on there TTX series...over kill maybe, however, I can here some slight noise from the springs.
|
1&done -
Just seeking some followup on your thrust bearings. Did you order a full set F/R and have you installed them and/or noticed any difference? Looking at the installation directions, it looks like they are placed against the base of each end of the spring -- all the other bits and pieces as described by Ohlins remain the same, right?