View Single Post
      10-31-2017, 11:50 AM   #8
houtan's Avatar

Drives: 2011 135i
Join Date: Jun 2013
Location: socal

iTrader: (13)

Garage List
2011 135i  [5.00]
Originally Posted by berns View Post
Nothing too crazy to see. Honestly, if you look under the rear fender, you'll see the flat lip that you'd otherwise roll. I just cut the whole thing off. No issues with two pieces of separate metal. Next time I'm under the car I'll try to snap some photos, but I already hit it with undercoat spray so it's hard to see.
Thanks for the reply. You use a cut of wheel to cut the lip? I am seriously thinking about trimming the rear fender lip. I am running 275/35 on arc 8s et62 with a 3mm spacer and just realized the tire is rubbing on the front upper part of the inner fender liner. 5mm spacer would do the trick but I get minor rubbing on the fender lip. Was going to use an angle grinder but now Iím thinking that is more work than cutting wheel.