Quote:
Originally Posted by ajsmithvmi
If someone wanted the conical adapters could the cad files be shared, perhaps for a nominal fee? Hypothetically of course.
|
Would not be interested in making money off the community like that, attached below. We did a small run of 72 units in our group buy, which ended up being around $21 AUD for a set of 4. I elected to choose stainless, but you could do make it out of other materials if you wanted. Could have used mild steel then zinc plated but didn't want to introduce more lead time and more steps.
Anyone interested in following how the project turned out from start to finish can see in my build thread here
https://www.1addicts.com/forums/show....php?t=1302309
Installation notes
Due to the fact that the Lemforder mounts are only 1.5mm narrower in width to the stock tapered bushings, there is no space to make a tapered washer 1.5mm thick. I ended up designing the washer to be 4.5mm thick, then pressing the ball joint offset 3mm to make the geometry the same.
Illustrations here:
https://www.1addicts.com/forums/show...&postcount=293