After waiting 2 months for the parts to arrive I just got around to installing this, the only minor issue I had was when tightening the passenger side brace over then strut, the arm was hitting an electrical cable. Upon tightening one of the nuts I actually saw a blue spark so I immediately stopped. Adding 2 washers over the inner most strut hole closest gave me enough clearance but then I had difficulty tightening down the main plastic cowl because the nuts overt the brace were touching. Not sure if that was exacerbated by the washers or not but no big deal.
2 washers over strut tower gave enough clearance:
Bar installed before putting the plastic trim back on:
