Quote:
Originally Posted by GoodMoodley
You have a nice set up as well.
What did you use to press the RSFBs. I have a bearing puller/press set that I am hoping will do the trick
|
https://www.amazon.com/Bearing-Adapt...l+bear&sr=8-13
I used this kit, has the the size i need. But i also need to buy a 1/2" threaded rod and some nuts and washers to use with the kit. The rod and nuts i got are grade 8, not the homedepot grade 3 or 5 stuff.
For the front bushings i had to bend the bushings lips inwards for the "cup" to fit.
The pulling part is not bad and a heat gun to heat the bushings helped alot. The most pain in the ass part is to get enough space since i didnt completely removed the subframe.
I also installed whiteline 2 piece bushings, so no pushing in is needed.
Ps: for front bushings the ID of the cup i used is 77.2mm, the OD of the puller piece is 71.7mm. Rear bushings cup ID 94mm, puller OD is 77.5mm. The threaded rod i cut it to about 8.5" long.