View Single Post
      05-01-2019, 11:16 AM   #5
Lieutenant Colonel

Drives: 2013 128i
Join Date: Jan 2016
Location: East Texas

iTrader: (0)

I'm going to do a minor detour/hijack here since there is such good experience participating in this thread...

When dropping the subframe where do you disconnect brake lines?
Are the brake line pipes actually attached to the subframe?
Do you plug the ends and with what?
How to avoid loss of much brake fluid?
I assume bleeding is necessary after reconnecting.

Asking because I need to tap out the mounting holes for the rear arb bracket and need to drop the subframe a good bit to be able to do so.
E82 / Ver Red / Blk Boston L / BMWP Springs w/ Koni Yellows / M front control arms / M rear guide rods / AT / Sport seats & steering wheel + paddles