View Single Post
      10-24-2016, 09:29 PM   #52
vtl
Colonel
vtl's Avatar
Australia
1021
Rep
2,917
Posts

Drives: 2008 BMW 135i MT
Join Date: Apr 2015
Location: Melbourne, Australia

iTrader: (0)

Installed AFE Magnum Pro5R oiled filter, just wanted a fresh filter since my current filter is already a few years old.

I have a BMC high flow panel filter which was great, but these filters take forever to clean and you probably won't get every last speck of dust out of it.

I think next time i'll just buy another BMC filter, the BMC's silicone moulding is a perfect fit, the AFE is not as good and requires some massaging to get the thing to seat. I also noticed that there was a loose wire stuck in the panel filter! That would have been bad if it got into the engine. Was also some bits of loose cottons strands in the filter too that I had to pick out.

Not really impressed so far with the AFE filter, have not driven it yet so will need to update again, although I doubt there will be any improvement.
Attached Images
 
__________________
Build Thread | MHD Custom Tune | Agency Power DPs | PE Mod Exhaust | 550i Clutch | Wagner FMIC | M3 LSD | Turbosmart Kompact DVs | M3 Control arms | M3 steering rack | KW V2 Coilovers | Dinan Camber Plates | E92 M3 Front Sway | UUC Trans mounts | Nolathane rear subframe bushings | Ferodo DS2500 pads | Yokohama AD08R | 18" BMW 313 Rims | Schroth Harness | M3 Steering Wheel | LEDs | CIC + Combox retrofit