Quote:
Originally Posted by Esteban
Well, your assistant looks exhausted. I hope he earned his wages, which should be at least 10 milk-bones per hour.
|
He gets more than that, spoiled little dude lol
Had some more fun today!
Finished sanding the base coat and painting the new rear diffuser... Sanded and ready for final coat of black before clear coat:
20170419_093936 by
Matt Steele, on Flickr
I decided to go with Testors enamel for the top black coat since it's highly durable and also flexible.
20170419_093946 by
Matt Steele, on Flickr
Next, my assistant helped me pick out some wood to make some poor-mans ramps..
20170419_124611 by
Matt Steele, on Flickr
They work perfectly! Made them in about 15 minutes and they cost less than $15.
20170419_142515 by
Matt Steele, on Flickr
Now I can finally reach that center jack-point!
20170419_142529 by
Matt Steele, on Flickr
20170419_142842 by
Matt Steele, on Flickr
I also picked up some 1x2 for my side jack points to cushion them from the jack stands. Works just as well and cost $2 instead of $25 for each friggin jack pad adapter.
20170419_143216 by
Matt Steele, on Flickr
Had to make a hardware store run and saw this in the lot:
20170419_145544 by
Matt Steele, on Flickr
Safety inspection:
20170419_173952 by
Matt Steele, on Flickr
Hood latch pin drilled and installed (mostly)
20170419_191116 by
Matt Steele, on Flickr
Template for the latch laid out, many prayers to the car-gods were made at this time
20170419_193825 by
Matt Steele, on Flickr
WEAR YOUR EYE PROTECTION. If I hadn't been wearing glasses, this would have been a very different post... Cutting disk disintegrated, brand new one and using it in a straight line through fiberglass. Guessing it was just a bad egg.
20170419_204737 by
Matt Steele, on Flickr
Drilling the holes for the screws after fitting the latch through the roof and cutting the inner panels for room
20170419_202447 by
Matt Steele, on Flickr
Assistant is on break.. How he sleeps through drilling, cutting, and my spontaneous cursing, I will never know...
20170419_202628 by
Matt Steele, on Flickr
Final steps
20170419_203857 by
Matt Steele, on Flickr
Dust ***ing everywhere but just about done!
20170419_213913 by
Matt Steele, on Flickr
Tomorrow hopefully I can finish the latches, the rear diffuser, and the wheel well liners. I'd have done the liners today but the shop forgot to give me half of the driver side