Quote:
Originally Posted by fastdrivingjr
I got it easy with this EASY
|
No Dice for me..... The rear cog came out easy, but the front will not budge.
Quote:
Originally Posted by djpeetur
after getting my drive door replace. i went through hell and back adjusting the window so it will seal properly.
TIPS to getting your door seal correctly
-Have a person from the outside hold the window up, in the proper seal position with the door closed shut. measure gaps from other door.
-From inside the car. Tighten the window from the inside with door closed.
i had the door semi close and then measured the gap and then i opened the door to tighten. WRONG WAY. TIGHTEN WITH THE DOOR CLOSED and in SEAL POSITION
also this mini cooper tool below helped too. A fancy body shop didn't even correctly set my window. they didnt even know how to take out the regulator correctly. they had to chop my window and regulator out to put in my new door. Finally my nightmare ended. Next time i would get them to repair the door before replacing. what a hassle. thats my rant. Hopefully this helps someone else.
|
Where can I buy this mini cooper tool??
Quote:
Originally Posted by jsp_1990
Thanks again for this useful post. I tried to do my F07 535i the other day and couldnt get the gear screw out.
FYR: This is just a cutting disc removal tool with an extra hole drilled in it XD.
|
Nice improv.... I wish I had something like that