Quote:
Originally Posted by Katkarot
I install the Belt last week and I did not remove the fan.
There is a video on how to remove the fan from Bavaria I think.
I can tell you that there are 2 clips that are holding the fan from the bottom of the intercooler. I did not discover this when I was doing my OFHG but found it during coolant flush. You have to unclip them before you can pull the fan out.
If you remove the plastic covering under
|
Quote:
Originally Posted by zx10guy
Forgot to also mention, you need a Torx 20 to unscrew the screws which secures the air intake to the core support. There are 4 of these screws.
Below is the belt routing I made up for the N55. Pulley sizes and location relative to each other and on the engine is not exact.
Attachment 1973979
|
I recently did this job without removing the radiator using a post in another section of the forum. I used the same routing as ZX10guy except my AC and power steering pump were reversed. May they were changed in the '13?