Quote:
Originally Posted by Suprgnat
Quote:
Originally Posted by ornicar
"It has no clue what direction the wheel is spinning, nor does the wheel speed sensor."
So if it is not the wheel sensor that indicate the direction of the wheel which sensor is it???
i have tried to test Without the front sensors (harness unplugged) & the rear sensors always indicate the wrong direction. see photo.
help & advice are welcome.
Thanks
|
Are you getting an error code that indicates a problem with the DCS in the rear? The error code you posted was for the front. If it were me I'd focus on the front as you grafted on parts from a completely different generation of vehicles.
The version of INPA I use does not indicate wheel spin direction. Software/OBC may guess wheel spin direction based on data from other sensors, but I suspect "wheel spin direction" doesn't apply to the E8x/9x chassis. |
I have no error on the rear except the rear pas sensor that just come to alarme me to change the pads.
i agree with you about the front, but i have tried to turn the sensors in differents location as to switch off them and the rears one are always read in the wrong way.
in INPA you can read the direction in Chassis/DSC/F5/F1/F1
there is two pages and the wheel direction is on the 2nd page (first one is the speed )
you can read it with ISTA too.
Maybe that i had this issue since the first day of the swap, but i had not noticed it.