Quote:
Originally Posted by martymil
With the evo comp 2 there is no bumper bar cutting at all, if you ever had the front end completely off the radiator support is separate to the front apron as the radiator sits on steel brackets and is held in place with two rubber grommet screws from the top, the only trimming you do is to the apron
I have fitted a number of these and the only mod you might have to do to the rib is using a heat gun to warm up and push it up if it hangs to low.
Cutting is for butchers
You have to relocate the front temp sensor cut the plastic that held it in place and trim the air guide or leave it out
Its quite involved to do it correctly but by no means a hack job if done right.
Great IC for stock turbos but struggles with upgraded ones or in high ambient temps.
|
Marty that Wagner Evo Comp 2 you would think should support a genuine 300rwkws right as that would be limit on 98 fuel