|
Hello from France, exactly in the same trip: from my oem HiFi to Individual. I want to verify some information about the correct wiring: how did you find that the pins 1 and 2 needs to be bridged by jumper? Because I have also a mulf and a CiC professional with the iDrive(2) and don't want to do the wrong way ... I have tested the 4 pins of the oem Ref plug (61-13-6-905-200): N°1 =?, N°2 is 12Volt, N°3 is Ground and N°4 = ?. So if you know what these two pins are for (mulf or other sensor) I would be glad to know !!
Other problem: when i tested the pins assignments of the HP plug (oem Ref 61 13 1 383 502): 1=Rear Side Left -- and 3=Rear Right ++ (inverted / the wiring diagram) and the pins negative Woofers (pins 16 + 18) not linked to the ground.
Before completing my upgrade, I want to know, anyway thanks for your Diy !!
PS: Pin 10 is +12V command start from the HU and Pin 20 is Ground.
oem Most Plug Ref is: 61 13 6 901 844
Fiber optical kit (serial mount between the modules): 61 12 0 142 318
Fiber protection: 61 13 6 918 242
If there is a Mulf, you don't need to unplug the Most distribution plug but only rely this one fiber between the Mulf and the Ampli.
|