Quote:
Originally Posted by MechE
Obiwun,
I just measured the position of the extensions in my car relative to the clip in the photograph. Please note that I did not remove the clip so it is possible my measurements may have some error since the center of the clip doesn’t necessarily align with the exact center of the hole in the liner.
1. Using a piece of paper as a flexible “ruler” that conformed to the curve of the liner, in the vertical direction, the distance is approximately 60mm from center-to-center. I DID NOT force the template to conform to the divot around clip, just the general curve of the liner.
2. In the horizontal direction, the center of the extension hole is approximately 4mm closer to the rear of the car than the center of the panel clip.
I hope that helps,
John
|
Wow, thanks for your efforts John. That will certainly make it easier for me to put the hole in the correct place. Thank you.
Toby