I just finished installing Corbeau FX1 with Corbeau 1-series seat brackets. Everything bolted right in, except the inner seatbelt tensioner. The seat rails have a bracket to bolt this to, but the threads and diameter are completely different than the oem “fillister-head screw”. I ended up contacting them for the bolt specs, buying additional bolts, and fabbing a “sleeve” so the bolt would fit within the hole on the tensioner.
Other than that, the seats fit perfectly to the rails and rails perfectly to the floor. Since the seats do not decline, it’s a pain to get stuff in/out of back seat. The seating position is about 3.5” lower than where I was sitting in the oem non-sport seats. I’m only 5’6” so I thiught it would be an issue but I got used to it within a couple drives.
Coded out same things as the post above, with some challenges. Seems that coding does depend on order of doing things: code everything out first, then disconnect battery, then unplug seats, then Reconnect battery.
|